Electrical Connection - Iberspa SM-COM-PR Manuel D'utilisation

4.4. Electrical connection

• This equipment cannot be connected to an ordinary plug.
• This equipment requires proper electrical installation. This should be performed by a
• specialist following the electrical safety regulations in each country.
• The connection must be earthed.
• Use a suitable cable section bearing in mind the power of the Spa and distance from
the switchboard.
• Always follow the instructions indicated in: Safety Warnings of this manual.
• Do not connect the electrical equipment (differential switch in the ON position) if the Spa
is empty.
WARNING
Do not try to access any electrical component unless you are qualified or are
the Head of Maintenance.
Never access electrical elements with wet feet..
DIFFERENTIAL SWITCH INSTALATION
The electrical installation should be fitted with a 2-pole, high sensitivity differential switch
in the general current input panel (the differential switch is not supplied with the Spa).
ATTENTION
It is essential that the owner of the Spa checks and resets the differential
switch from time to time to check its good working order. It is recommended
to do this at least once a month.
12
048