Iberspa SM-COM-PR Manuel D'utilisation page 34

Sensors are out of
sync -- Call for service
-- M026
Sensor A Fault, Senor
B Fault – Sensor A:
M031, Sensor B: M032
Comunications error
Test software
installed
Program memory
failure – M022
The settings have
been reset (Persistent
Memory Error) – M021
The clock has failed
– M020
Configuration error
(Spa will not Start Up)
A pump may be stuck
on – M034
Hot fault – M035
** Some messages can be reset from the panel. Messages that can be reset will appear with a
Clear Icon at the bottom of the Message Screen. Press the Clear Icon text to reset the message.
34
The temperature sensors are out of sync
A temperature sensor or sensor circuit
has failed.
The control panel is not receiving
communication from the System.
The Control System is operating with test
software.
At Power-Up, the system has failed the
Program Checksum Test.
Water may be overheated.
A Pump Appears to have been Stuck
ON when spa was last powered POWER
DOWN THE SPA.
The fault above has been established for at least an hour.
Call for service. See **
If the problem persists, contact your vendor or a service
engineer.
See: **.
If the problem persists, contact your vendor or a service
engineer.
If the problem persists, contact your vendor or a service
engineer.
This indicates a problem with the firmware (operation
program) and requires a service call.
See: **.
Contact your service organization if this message appears on
more than one power-up.
See: **.
If the problem persists, contact your vendor or a service
engineer.
See: **.
If the problem persists, contact your vendor or a service
engineer.
POWER DOWN THE SPA. DO NOT ENTER THE WATER.
Contact your dealer or service organization.
DO NOT ENTER THE WATER.
If the problem persists, contact your vendor or a service
engineer.