Arneg Sendai Manuel D'installation page 45

- Polyurethane foam (R134a): thermal insulation
The user is responsible for delivering the product for disposal to the collection
centre specified by the local authorities or manufacturer for the recovery and
recycling of materials.
All these operations, as for transport and waste processing, should be
performed by authorised, specialised personnel only.
This product contains HFC, a refrigerant with a high greenhouse effect
potential (GWP). ARNEG uses the following types of refrigerant in models
produced with built-in refrigeration units:
R 134a; GWP
R 404A; GWP
belonging to the HFC family, namely hydrofluorocarbon gases with a high
global warming potential (GWP), governed by the Kyoto protocol. (Check
which of these two gases is in the appliance by reading the plate or adhesive
label on the device) therefore:
THE COMPONENTS OF THE REFRIGERATION CIRCUIT SHOULD NEVER
BE CUT AND/OR SEPARATED. THEY MUST BE RETURNED INTACT TO A
CENTRE SPECIALIZING IN THE RECOVERY OF REFRIGERANT.
This device is hermetically sealed and the refrigerant load is less than 3
kg.
Therefore it is not subject to an obligatory system manual nor regular
inspections for loss of refrigerant (Italian Presidential Decree no. 147 of
February 15, 2006, articles 3 and 4).
DUE TO THE CONTENT OF INFLAMMABLE PROPANE GAS, SENDAI 1000
R290 REQUIRES PARTICULAR CARE DURING DISASSEMBLY, WHICH
MUST BE CARRIED OUT EXCLUSIVELY BY AUTHORISED PERSONNEL.
05060048 01 13/06/2012
= 1300
(100)
= 3750
(100)
Sendai-SendaiR290
English
45