Arneg Sendai Manuel D'installation page 37

3 Remove the glass-holder profile (H) sliding it
out from the glass-holder profile support (I)
4 Remove the glass-holder profile support (I),
unscrewing the screws that attach it to the
cabinet.
5 Remove the output assembly:
A - trays
F - corners
L - rear glass
M - plexiglass structure
N - anti-condensation deflector
6 Remove the glass-holder profile (H) sliding it
out from the glass-holder profile support (I)
7 Remove the glass-holder profile support (I),
unscrewing the screws that attach it to the
cabinet.
8
REAR CABINET (air discharge)
9 Store the removed components
10 To reassemble the intake and output assemblies, carry out the above operations in
reverse order.
Remount the glass-holder profile to the front part, making it "snap" along the
entire length of the cabinet. DO NOT insert it from the side casing
Check that it safely supports the glass.
05060048 01 13/06/2012
Sendai-SendaiR290
M N
A
FRONT CABINET (air suction)
English
I
H
L
F
I
H
37