Installing Paper On The Internal Printer - SciCan AUTOCLAVE STATIM 2000S Manuel De L'utilisateur

6. The Communication Port con't.

6.3 Installing Paper on the Internal Printer

Use only paper approved for use with the optional internal printer on the Statim 5000S.
The use of any other paper will damage the printer and will void the warranty. Thermal
paper is available from SciCan (SciCan order no. 01-101657S).
Do not operate the printer without paper. If you run out of thermal paper, or if you do not wish
to use the printer, turn it
Never pull the paper backwards through the printer.
This will damage the printer mechanism.
To install the paper into the printer, follow these steps:
1. Power the Statim 5000S
2. Open the printer door
3. Power the printer
4. Unroll some paper from the thermal paper roll
cutting template included with each box.
5. Move the paper roll arm
the paper strip feeds from the top of the roll and then carefully insert it into the paper feed
slot
If the paper does not feed from the top, the heat sensitive side of the paper will not be in
contact with the print head and the printer will not print.
6. With one hand, continue to gently feed the paper strip into the paper feed slot. With the
other hand, press the paper advance button until the paper feeds by itself.
Keep the paper straight when feeding it into the printer or it may jam. Do not force the paper
into the slot! If the paper will not feed into the slot, pre-cut the end of the roll again and reload
the paper.
OFF
.
ON
n
by pushing on the top half of the door.
1
ON
.
n
4
n
until it stops.
5
.
n
and trim the corners using the paper
3
into the loading position. Place the paper roll
29
n
on the arm so
3