SciCan AUTOCLAVE STATIM 2000S Manuel De L'utilisateur page 26

6. The Communication Port con't.
6.2 Installing the SciCan Data Logger
SciCan's USB Data Logger can record and store cycle information onto a mass storage
device (MSD) such as a USB Flash Drive or SD memory card.
These instructions are for units with a 9-pin communication (RS232) port located at
the back of the unit.
Follow the steps below before connecting the Data Logger.
User Mode
Time/Date Setup
Language Setup
Unit ID Setup
Water Quality
Last Printout
RS232
End Of Line CR/LF
Serial Port Bitrate
Printer user ° char
Save and Exit
Exit
STEP 1
Selecting the USB Flash/MSD Option
RS232
1. Power up unit while pressing the STOP button to access the User Setup menu.
2. Using the UNWRAPPED and WRAPPED buttons, scroll to RS232 and select it by
pressing the RUBBER AND PLASTIC button.
3. From the RS232 menu, use the UNWRAPPED and WRAPPED buttons to scroll down to
the USB/FLASH MSD option and press the RUBBER AND PLASTIC button to select and
return to the User Setup menu.
User Setup Menu
To install the SciCan Data logger,
access the user setup menu by powering
up the unit while pressing the STOP
button. Follow the instructions below to
complete installation steps.
USB/Flash MSD
26