SciCan AUTOCLAVE STATIM 2000S Manuel De L'utilisateur page 30

6. The Communication Port con't.
7. Continue to press the paper advance button
the paper feeds through the paper exit slot on the
front of the printer. Then, move the paper roll
and arm into the operating position and close the
printer door
When you see a red line on one side of the paper, it
is time to replace the roll.
If a paper jam occurs, and the paper cannot be
removed by pressing the paper advance button
do not pull the paper backwards through the printer.
Never put a utensil or tool into the paper exit slot. For
full instructions on how to remove paper jams, see
section 6.4 Removing Internal Printer Paper Jams.
To replace the paper roll
1. With scissors, cut the paper between the roll and
the paper feed slot
2. Remove the roll from the arm and discard the
unused portion.
3. Press the paper advance button
paper that remains in the printer out of the slot at
the front of the printer.
4. Install the new thermal paper roll by following the
instructions described in this section.
n
. The printer is now ready to operate.
1
n
, follow these steps:
3
n
.
5
n
6
n
until
6
n
3
n
,
6
to feed the
30
n
5
n
2
n
n
4
3
n
4
n
6
Figure 15.1
n
5
n
2
n
6
Figure 15.2
n
3
n
1