Running A Cycle - SciCan AUTOCLAVE STATIM 2000S Manuel De L'utilisateur

4. Instructions For Use Con't.

4.7 Running a Cycle

To operate each cycle, follow these steps and watch the LCD .
1. Turn the power switch
at the back of the unit to ON.
The LCD display reads:
2. Press the appropriate cycle button on the
keypad to scroll through the available cycles
The display will read either:
HOLLOW UNWRAPPED
(S) 134˚C / 3.5 min
HOLLOW UNWRAPPED
(S) 134˚C / 18 min
SOLID UNWRAPPED (N)
134˚C / 3.5 min
As the button is released the display reads:
Cycle you selected
PRESS START
The unit's cycle counter is displayed at the start, after the start button is depressed.
Cycle you selected
CYCLE NUMBER
The amber indicator light comes on. To indicate that the cycle is in progress, the following
messages are displayed as the cycle runs.
Cycle you selected
WARMING UP
As the cycle is running,
various sounds will be heard.
This is the normal functioning of the unit.
14:23
SELECT A CYCLE
HOLLOW WRAPPED (S)
or
134˚C / 3.5 min
HOLLOW WRAPPED (S)
134˚C / 18 min
000000
CONDITIONING
110˚C 143 kPa
PRESSURIZING
125˚C
11/15/2006
RUBBER / PLASTIC (S)
or
232 kPa
STERILIZING
136.8˚C 330 kPa 3:29
19
121˚C / 15 min
RUBBER / PLASTIC (S)
121˚C / 30 min
VENTING
108˚C 134 kPa