Save And Exit - SciCan AUTOCLAVE STATIM 2000S Manuel De L'utilisateur

6. The Communication Port con't.
Setting the Serial Port Bitrate to 9600
Serial Port Bitrate
1. From the User Setup menu, use the UNWRAPPED and WRAPPED buttons to scroll to
the Serial Port Bitrate menu and select it using the RUBBER AND PLASTIC button.
2. From the Serial Port Bitrate menu, use the UNWRAPPED and WRAPPED buttons to
scroll down to 9600 and press the RUBBER AND PLASTIC button to select and return to
the User Setup menu.
Setting the Printer user Character; (example: 134°C)
Printer user ° char
1. From the User Setup menu, use the UNWRAPPED and WRAPPED buttons to scroll to
the Printer user ° char menu and select it using the RUBBER AND PLASTIC button.
2. From the Printer user ° char menu, using the UNWRAPPED button to increase the
displayed value by one, and the WRAPPED button to increase that value by ten, enter
the value 32 [0x20] and press the RUBBER AND PLASTIC button to accept and return to
the User Setup menu.

Save and Exit

Save and Exit
A Save and Exit must be performed after the above settings are completed. If this is not
done, the information will revert to its prior settings.
1. From the User Setup menu, use the UNWRAPPED and WRAPPED buttons to scroll to
Save and Exit.
2. Select it by pressing the RUBBER AND PLASTIC button.
The LCD will display time and date
information and a sequence of
messages:
9600
32 [0x20]
HH:MM DD/MM/YYYY
"MSD NOT DETECTED"/"INSERT MSD/
FLASH"/"SELECT A CYCLE"
27