SciCan AUTOCLAVE STATIM 2000S Manuel De L'utilisateur page 37

7. Troubleshooting con't.
Excessive steam issuing from the front
of the machine.
Message WATER QUALITY IS NOT
ACCEPTABLE. Machine will not start.
Message REFILL RESERVOIR,
Machine will not start.
Message PRINTER FAULT displayed on
LCD Printer is not printing.
The printer does not work.
The printer appears to work, but nothing is
printed on the paper.
Time and date are incorrect.
Remove and reinsert the cassette. Attempt another
cycle. Remove and check the cassette seal for
misalignment or damage. Replace the seal if required.
Be careful as the metal parts will be hot and the
cassette will contain hot steam.
If the leak persists, turn the unit OFF, remove and
unload the cassette and contact your SciCan dealer.
You have used water which is not steam-process
distilled or is improperly distilled.
Empty the reservoir and refill with steam-process
distilled water containing less than 5 ppm total disolved
solids (having conductivity of less than 10 µS / cm).
If you have the water conductivity meter, check the
quality of the water before refilling the reservoir.
Refer to the steps described in section 3.9 Shipping
the Unit to empty the reservoir.
The level of the water in the reservoir is low. Refill the
reservoir. Refer to the steps described in section 3.4
Filling the Reservoir.
Check for a paper jam. If the paper is jammed, follow
the paper removal procedures outlined in section 6.4.
Power unit OFF for 10 seconds and then power
ON again. If the paper is still jammed, follow the
disassembly procedures outlined in section 6.4
Removing Paper Jams.
Make sure that the printer cable is connected
securely with the connector on the back of the Statim
and the Statprinter. Make sure that the printer is
powered ON. Power unit OFF for 10 seconds and
then power ON again.
Ensure that the paper is loaded properly (refer to
section 6.3 Installing Paper on the Internal Printer).
Check to see that the paper leaves the paper roll from
the top of the roll. This means that the treated surface
of the coated thermal paper will be in contact with the
thermal print head.
The time and date have not been set. See section 3.6
Setting the Time and Date.
37