Receipt; Unpacking And Handling; Long Term Storage - Ingersoll Rand R4-11 kW Mode D'emploi

EN

RECEIPT


Before signing the delivery receipt, inspect for damage and missing parts. If
damage or missing parts are apparent, make the appropriate notation on the
delivery receipt, then sign the receipt. Immediately contact the carrier for an
inspection.
All material shall be held in the receiving location for the carrier's inspection.
Delivery receipts that have been signed without a notation of damage or
missing parts are considered to be delivered "clear. " Subsequent claims are
then considered to be concealed damage claims. Settle damage claims
directly with the transportation company.
If you discover damage after receiving the compressor (concealed damage),
the carrier shall be notified within 15 days of receipt and an inspection shall
be requested by telephone with confirmation in writing. On concealed
damage claims, the burden of establishing that the compressor was
damaged in transit reverts back to the claimant.
Read the compressor nameplate to verify it is the model ordered, and read
the motor nameplate to verify it is compatible with your electrical conditions.
Make sure electrical enclosures and components are appropriate for the
installation environment.
EN-4
RELEASED 16/Dec/2014 10:49:53 GMT

The compressor will normally be delivered with a polyethylene or other
cover. If a knife has to be used to remove this cover, ensure that the exterior
paintwork of the compressor is not damaged.
Incorporated within the base of the compressor are slots to enable a fork lift
truck to move the compressor. Ensure truck forks are fully engaged on both
sides. Alternatively a special lifting frame can be used to enable a crane or
hoist to move the compressor. Use only marked lifting points.
Once the packaging and pallet are discarded and the compressor is in its
final position, remove the yellow painted transit brackets from the resilient
mounts and store for future use or discard.

If the product is not immediately commissioned upon receipt, the motor and
airend should be moved 1/2 turn every three months to prevent damage to
the bearings. If the product will not be commissioned within six months of
receipt, it should be prepared for long term storage. Contact Ingersoll Rand
for more details.

UNPACKING AND HANDLING

LONG TERM STORAGE

80448483 Rev.B