Normstahl Prominent Notice De Montage Et De Fonctionnement page 5

[D000370] Activities, which require Professional installer:
Any alterations and modifications to the door should be agreed on with the
manufacturer.
The range of works covered with the door periodical inspection provided by
a manufacturer's authorised service centre.
• Identify the door type, serial number.
• Check the door marking, warning labels. Add new ones, if missing.
• Check the connection parts used in the door: anchors mounting the door to
wall, screws mounting the guides.
• Check the springs and elements working with them. In case of evident wear
and tear signs, the elements should be absolutely replaced.
• When the door is used longer than 12 years, or if the door made more
than 10 000 cycles (the number of cycles should be estimated on the basis
of the interview with the door owner) - the springs should be absolutely
replaced.
• Pay attention to conditions, in which the door is operated. If the conditions are
different from the required operation conditions, the owner should be informed
about possible consequences (e.g. about failure occurrence possibility).
[C000235] Activities, which may be performed by a manufactur-
er's authorised service centre:
• any modifications to the door,
• replacement of springs counterbalancing the door leaf,
• repairing works of electric components,
• repairing works of door components.
Disconnect power supply of the drive when performing
any door maintenance and inspection works. Fastening
of springs counterbalancing the door leaf can only be
loosened when the door is fully open.
[A000011] All works must be performed according to this Assembly and Oper-
ating Instruction of the door. Any comments or recommendations must be submit-
ted to the Owner in writing, e.g. to be noted in report book of the door or war-
ranty card, and submitted to the door Owner. Upon performing the inspection,
this fact must be confirmed by corresponding note in report book or warranty
card of the door.
[A000068] the manufacturer reserves the right to introduce de-
sign modifications due to technological progress that do not alter
the product functionality, without prior notice.
this documentation is copyright of the manufacturer. Copying,
reproduction and usage in full or in a part without the written
consent of the owner is prohibited.
Technical documentation IIiO/BGU/12/2012/ID-93551

Assembly and Operating Instructions – Up and over garage door
EN
5