Maico PP 45 O Notice De Montage page 47

LEDs
LED flashing modes:
Parameter Set value /
ventilation level
0
Power units
(LT) or 1
room air 2
controls 3
(RLS) 4
5
6
230 V AC 1
input 2
3
4
5
6
0
Sensors
1
2
3
4
5
6
7
LED flashing rapidly
Setting /
description
Operation without further LT/RLS
Operation with 1 LT or RLS
Operation with 2 LT or RLS
Operation with 3 LT or RLS
Slave no. 1
Slave no. 2
Slave no. 3
Adjuster for adding further room air
controls (RLS) or power units (LTs) to
this room air control. Example: Two
further RLS (RLS #2 and #3) are con-
nected to RLS #1. Set value = 2. Set
set value 4 on RLS #2 and set value 5
on RLS #3.
Notice: Only single-type RLS combi-
nations are permitted!
Sleep mode
Intermittent ventilation
Safety shutdown
Supply air operation without overrun
Supply air operation with overrun time
of 6 min.
Supply air operation with overrun time
of 15 min.
For setting an additional function.
This can be activated with a button
or switch at the 230 V input.
No sensor
1 internal sensor
1 internal sensor + 1 external sensor
1 internal sensor + 2 external sensors
1 internal sensor + 3 external sensors
0 internal sensors + 1 external sensor
0 internal sensors + 2 external sensors
0 internal sensors + 3 external sensors
Select how many internal and external
sensors are connected/combined.
The PP 45 HYI internal sensor and
the PP 45 HY, PP45 CO2 and PP 45
VOC external sensors are available.
LED flashing slowly
10 Start-up | UK
47