Maico PP 45 O Notice De Montage page 37

Slide-in module
1 Fan connection cable with connector
2 Pull-out bracket
3 Filter seat
4 G2 air filter
5 Fan unit
6 Profile seal
7 Ceramic heat exchanger
8 G3 air filter
9. Ensure that the air filters lie flat in the
seats.
CAUTION
!
Danger of injury/damage to unit from
falling slide-in module (3 kg). Sometimes
the slide-in module is hard to slide in. Ensure
that they are always securely supported and
that there is not anyone under the unit. When
installing and removing the slide-in module,
support it from below with a hand.
10. Slide slide-in module into wall sleeve.
Min. wall thickness 265 mm, slide-in mo-
i
dule must not protrude out of wall sleeve
The profile seal on the outside of the
drawer is used for fixing and avoidance
of false air. The motor connection cable
must not be strained when installed. When
sliding in the drawer ensure that the Oben/
Top sticker is facing upwards.
11. Press fan connection cable into notch
( arrow) so that it is fixed and not
strained.
PP 45 O
12. With units (12 V DC)
Insert enclosed plate [11] in the 2 locking
tabs so that it engages. Wire connector
[10] with the 12 V control cable of the
room air control ( diagrams in appen-
dix). Attach connector [10] on plate [11]
( Fig.) and connect with connector [9].
PP 45 K
13. With units (12 V DC)
Loosen screw for board cover, take off
board cover. Insert fan connection cable
[9] directly on board. Wire the 12 V control
cable of the room air control ( diagrams
in appendix). Fit board cover.
14. Attach front cover of internal housing at
top in two housing studs and swivel down
until front cover engages on locking lever.
Before putting on the front cover of
i
the internal housing, the shutter must
always be open. To do this, switch on
PP 45 K or RC unit. For PP 45 O, set
the rotary knob to "Open".
PP 45 RC
15. With units (230 V AC)
 Chapters 9.3 and 9.4.
9 Mounting | UK
37