Starting Sequence - Festo MPS 8082795 Notice D'utilisation

15.2 Starting sequence

Start-up prerequisites
The following conditions must be fulfilled:
•
A visual inspection has been completed.
•
Functioning of the protective device has been checked.
Caution
If any damage is detected, there is a danger of injury during operation.
Malfunctions which may impair safety must be reported to appropriately trained
personnel and eliminated immediately!
Pneumatic gripper in incorrect position.
•
The power supply is connected and switched on.
•
The stepper motor control cables are connected.
•
The compressed air supply is connected and activated.
After all start-up prerequisites have been met, the green reset LED will light up on the control desk.
© Festo Didactic 8083287
•
The pneumatic gripper (1) is in home
position, i.e. outside of the slot (2).
If necessary, you will need to position
the pneumatic gripper manually
outside the rack.
Storing/Conveyor station
69