Switching Between °C/°F Temperature Units; Outdoor Temperature Trend Display - Eurochron EFWS 700 Mode D'emploi

i) Deleting the MAX-/MIN-Values
—
Briefly push the button "MAX/MIN" (8), so that either the MAX- or the MIN-
values are displayed (the display shows "MAX" or "MIN" above the temperature/
humidity values).
—
Delete all stored MAX/MIN values by pushing the button "MAX/MIN" (8) for 3
seconds until a sound is issued.
The new MAX/MIN values will then be the current measured values until
they change again.
j) Switching between °C/°F Temperature Units
—
Briefly push the button "°C/°F" (4) at the basis station to switch the temperature
unit between °C (degrees Celsius) and °F (degrees Fahrenheit).
—
To switch the outdoor sensor display between °C and °F, briefly push the button
"°C/°F" (23) in the battery compartment of the outdoor sensor.
k) Setting the Current Weather
For the weather forecast to work more precisely, you may set the current weather
from time to time. This should also be done when the basis station is set up at a
higher or lower place.
The first weather forecast is possible at the earliest 6 hours after inserting
the batteries into the basis station or 6 hours after setting the current
weather.
—
Hold down the "WEATHER" button (12) for three seconds until the sound signal
is issued. The weather forecast symbol flashes.
—
Set the current weather with the buttons "+" (2) or "-" (4). Alternatively, you
can also push the button "WEATHER" (12) briefly several times.
—
To terminate setting mode, wait for about 15 seconds without pushing a button.
The weather forecast symbol stops flashing.
l) Outdoor Temperature Trend Display
At the top right of the outdoor temperature display, the temperature development
trend is shown:
Rising Consistent Dropping
57