Setting Time/Date - Eurochron EFWS 700 Mode D'emploi

12. SETTING TIME/DATE

As already described in chapter 10, it may be required in case of bad DCF-reception
that the time and date be set manually.
Both for manual setting and for DCF-reception, the order of day and month in the
display, the time zone and language can be chosen when displaying the weekday
abbreviations.
When DCF-reception is active, skip the time and date setting (do not change
anything).
If time or date are misadjusted by accident, you can then simply perform a
new reception attempt for the DCF signal so that the basis station displays
the DCF data again.
Proceed as follows:
—
The basis station must be close to the regular time display (not in, e.g., the
display of the alarm time).
—
Hold down the "MODE" button (5) for about three seconds until the sound signal
is issued.
The hours display flashes.
When no button is pushed for about 15 seconds, the current setting is
assumed and the setting mode left automatically.
—
Set the hours with the buttons "+" (2) or "-" (4), if desired. Keeping the respective
button down for some time will adjust quickly.
Please note:
When the DCF-reception is active, adjustment of the time (hours/minutes/
seconds) or date (year/month/day) switches it off. The reception symbol " "
(N) vanishes from the display.
As already described above, just continue setting (e.g. order of day and
month, time zone or language for the weekday). Then start a new reception
attempt for the DCF signal.
—
Briefly press the button "MODE" (5).
The minutes display flashes.
—
Set the minutes with the buttons "+" (2) or "-" (4). Keeping the respective button
down for some time will adjust quickly.
49