Perform Manual Dcf Reception Attempt - Eurochron EFWS 700 Mode D'emploi

The reception symbol (N) has the following meanings:
—
The reception symbol flashes when the basis station is looking for the DCF signal.
—
When the reception symbol is permanently displayed, the last reception attempt
of the DCF signal was without problems.
—
When the reception symbol is missing in the display, either the last reception
attempt failed or the time was set manually.
If the DCF signal cannot be received where the basis station is set up, set
the time and date manually; see chapter 12.
b) Perform Manual DCF Reception Attempt
Keep the button "-" (4) pressed for 3 seconds.
The basis station then emits a sound signal and the symbol for DCF reception " "
(N) starts to flash.
Do not move the basis station during reception; this takes about 5 minutes.
Do not push any key.
If no current time is displayed after 5 minutes either, you may either start a
new search or set the time manually; see chapter 12.
47