Alarm Function; Displaying The Alarm Time; Setting The Alarm Time; Activating/Deactivating The Alarm Function - Eurochron EFWS 700 Mode D'emploi

13. ALARM FUNCTION

a) Displaying the Alarm Time
Push the button "MODE" (5) briefly several times to switch between the time, date
and alarm time display.
"ALM" is shown above the alarm time.
b) Setting the Alarm Time
—
Push the button "MODE" (5) repeatedly as described in chapter 13. a) until the
alarm time is displayed.
—
Hold down the "MODE" button (5) for about three seconds until the sound signal
is issued.
The alarm time hours flash.
—
Set the alarm time hours with the -buttons "+" (2) or "-" (4). Keeping the
respective button down for some time will adjust quickly.
When no button is pushed for about 15 seconds, the current setting is
assumed and the setting mode left. Then the time is displayed again.
—
Briefly press the button "MODE" (5).
The alarm time minutes display flashes.
—
Set the alarm time minutes with the buttons "+" (2) or "-" (4). Keeping the
respective button down for some time will adjust quickly.
—
Briefly press the button "MODE" (5) to terminate setting mode.
—
To return to the time display, either push the button "MODE" (5) repeatedly or
wait for a few seconds without pushing a button.
c) Activating/Deactivating the Alarm Function
Briefly press the button "ALARM" (1) to activate or deactivate the alarm function.
When the alarm function is switched off, the symbol "
seconds display.
52
" (K) appears above the