Silencing The Alarm And Using The Snooze Function; Using The Backlight; Viewing The Atmospheric Pressure Readings; Viewing The Dew Point - Eurochron EFWS S250 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

b) Silencing the alarm and using the snooze function
• An alarm tone will be played at the preset alarm time, and the bell symbol (
display. The alarm will turn off automatically after one minute.
• To snooze for 5 minutes, press the LIGHT/SNOOZE button (12) when the alarm goes off. The
snooze symbol (Z
process will be repeated until you turn off the alarm.
• Press any other button (apart from the LIGHT/SNOOZE button) to turn off the alarm.
c) Using the backlight
• Press the LIGHT/SNOOZE button (12) to turn on the backlight for approx. 10 seconds (when
batteries are inserted).
• Press the LIGHT/SNOOZE button to change the brightness (when the power adapter is connected).
There are two brightness settings.
d) Viewing the atmospheric pressure readings
• Press and hold the BARO./- button (2) for approximately 2 seconds to switch between the absolute
and relative pressure readings. "ABS" indicates the absolute pressure; "REL" indicates the relative
pressure.
• Press the BARO./- button (2) to display the average pressure reading. Press the BARO./- button
again to display the average pressure reading for the last 12, 24, 48, and 72 hours.
e) Viewing the dew point
• Press the TEMP./+ button (4) to display the dew point. "DEW POINT" will be displayed next to the
reading. Press the TEMP./+ button again to go back to the home screen.
• You can also go back to the home screen by pressing the LIGHT/SNOOZE button (12), or by waiting
for 30 seconds.
f) Disabling the frost alarm
• The weather station features a frost alarm that goes off when the outdoor temperature is between
-3 and +2 °C. You can turn the acoustic alarm on or off as desired. The
when the alarm goes off. The alarm will turn off automatically when the temperature drops below
-3 °C or rises above +2 °C.
• To stop the alarm manually, press any button. The
but there will be no alarm tone.
) will appear on the display. The alarm will go off again after 5 minutes. This
z
symbol will still be shown on the display,
) will flash on the
symbol will flash
39

Publicité

Table des Matières
loading

Table des Matières