Silencing The Alarm; Snooze Function; Temperature Display; Switching The Temperature Unit - Eurochron EFWS 310i Notice D'emploi

• Press and hold the ALARM button until the displayed number (15, 30, 45, 60 or 90) flashes.
Use the ▲ or ▼ buttons to adjust the minutes for the pre-alarm.
• Briefly press ALARM button to exit setting mode.
j) Silencing the alarm
When the alarm signal sounds at the time set, it may be stopped by pressing the ALARM
button (9).
If you do not manually silence the alarm signal, it will repeat after approx. 8 minutes
(for a total of 3 times).
k) Snooze function
When the alarm signal sounds at the time set, press the SNOOZE button (10) to activate the
snooze function. The alarm will sound again after 8 minutes.

13. Temperature display

a) Switching the temperature unit
• Briefly press the ▲ or ▼ buttons (3 or 5) repeatedly until the
• Press and hold the MODE button (2) for approx. 3 seconds until the temperature unit (°C/°F)
for the indoor/outdoor temperature is switched.
b) Selecting an outdoor sensor
The weather station can receive and display the measured data of up to 3 outdoor
sensors. Each outdoor sensor must be set to a different transmission channel.
The outdoor sensor enclosed is set permanently to Channel 1; this cannot be
changed.
The sensors available as accessories have a channel selection switch, which you can
set to Channel 2 or Channel 3.
icon flashes.
53