Outdoor Sensor; Weather Station - Eurochron EFWS 310i Notice D'emploi

a) Outdoor sensor
• Open the battery compartment (22) on the back of the outdoor sensor by sliding the battery
compartment lid downwards slightly so that it can be taken off.
• Insert two AAA/micro batteries in the correct polarity into the battery compartment of the
outdoor sensor (observe plus/+ and minus/-).
• Replace the battery compartment cover.
• The included bracket (21) can be used as both a wall bracket and base. Depending on the
desired installation location, it can be attached to the top, bottom and also the rear of the

outdoor sensor.

The outdoor sensor is intended for use in protected outdoor areas. It should be placed
so that it is not subject to direct solar irradiation or rain/snow, because measured
values may otherwise be incorrect.
When installing the outdoor sensor, ensure that the battery compartment points down
so that no water may enter it.
Never immerse the outdoor sensor in or under water; this will destroy it!
The weather station can receive and display the measured data of up to 3 outdoor
sensors. Each outdoor sensor must be set to a different transmission channel.
The outdoor sensor enclosed is set permanently to Channel 1; this cannot be
changed.
The sensors available as accessories have a channel selection switch, which you can
set to Channel 2 or Channel 3.
b) Weather station
• Remove the battery compartment cover (6) on the back of the weather station.
• Then insert two AA/mignon batteries into the battery compartment of the weather station in
the correct polarity (observe plus/+ and minus/-).
• Replace the battery compartment cover.
• After inserting the batteries, the display briefly shows all display segments.
43