Using The Power Adapter; Inserting The Batteries Into The Outdoor Sensor - Eurochron EFWS S250 Notice D'emploi

For best results, avoid using rechargeable batteries. Rechargeable batteries provide a
lower voltage (rechargeable battery = 1.2 V, conventional battery = 1.5 V) and have a lower
capacity, resulting in a shorter battery life. If you do wish to use rechargeable batteries,
ensure that you use special NiMH rechargeable batteries with a low self-discharge. For
safety reasons and to ensure a longer battery life, we recommend that you use alkaline
batteries from a reputable manufacturer
b) Using the power adapter
• Connect the power adapter cable to the low voltage power-in socket (18) on the back of the weather
station.
• All display symbols will appear briefly on the LCD display. You will hear a short beep, indicating
that the weather station is ready to use. The reception symbol (
3 minutes. This indicates that the weather station is searching for a signal from the outdoor sensor.
The backlight will turn on.
If there are batteries inserted, the weather station will automatically use the power supply
from the power adapter..
c) Inserting the batteries into the outdoor sensor
Use lithium batteries when using the outdoor sensor in cold climates (lithium batteries are
less sensitive to cold weather). Alkaline batteries are sufficient for other climates.
Replace the batteries when the symbol is displayed on the weather station.
• Open the battery compartment cover (D) on the back of the outdoor sensor.
• Insert two AA batteries (not included) into the battery compartment, ensuring that you pay attention
to the polarity markings (plus/+ and minus/-).
• All display symbols will appear on the LCD display. The outdoor sensor is now ready to use. It will
send weather data to the weather station for approximately 5 seconds and then start to search for
a DCF signal.
• Replace the battery compartment cover.
Insert the batteries into the outdoor sensor after setting up the weather station. The weather
station will only be able to receive data from the sensor when the reception symbol is
flashing on the weather station's LCD. The outdoor sensor should be located at a distance
of 5–10 m from the weather station.
) will flash for approximately
35