Setting The Time Zone; Select An Alarm Or View Alarm Time; Enabling/Disabling The Alarm - Eurochron EFWS 310i Notice D'emploi

e) Setting the time zone
• Briefly press the ▲ or ▼ buttons (3 or 5) repeatedly until the
• Briefly press the MODE button (2) until the indicator "ZONE" appears to the right of the time.
• Press and hold the MODE button until the time zone display begins flashing ("0:00+").
• Use the ▲ or ▼ buttons to set the time zone (press and hold for quick adjustment). The
value may be adjusted between -13 and +15 hours.
• Briefly press MODE button to exit setting mode.
f) Select an alarm or view alarm time
• Briefly press the ▲ or ▼ buttons (3 or 5) repeatedly until the
• Briefly press the ALARM button (9) several times until the desired alarm appears.
: The alarm will be activated only on workdays (Monday to Friday).
: The alarm sounds only once; then it is automatically switched off ("OFF").
PRE-AL: At low outdoor temperatures, below 0 °C (measured by the outdoor sensor
with Channel 1), the so-called pre-alarm sounds at a settable interval (15, 30, 45, 60 or
90 minutes) before the actual alarm time. This gives you sufficient time to e.g. clear your
windscreen from ice or to shovel snow.
For the pre-alarm (PRE-AL) to be switched on or set, you must first switch on one of
the other two alarms (W or S).
g) Enabling/disabling the alarm
• Briefly press the ▲ or ▼ buttons (3 or 5) repeatedly until the
• Briefly press the ALARM button (9) several times until the desired alarm appears.
• Use the ▲ or ▼ buttons to switch the selected alarm on (alarm time is shown) or off ("OFF"
appears on the display).
For the pre-alarm (PRE-AL) to be switched on or set, you must first switch on one of
the other two alarms (W or S). Otherwise the pre-alarm feature is not available.
icon flashes.
icon flashes.
icon flashes.
51