Setting The Alarm Time And Weather Alarm - Eurochron EFWS2900 Notice D'emploi

• Repeat this process in the same way to set the month and day.
• Press the SET button once you have completed each setting. The air pressure unit will start to flash. Press the
WIND + or PRESSURE - buttons to change the unit. Confirm your selection with the SET button. The air pressure
calibration setting will start to flash. If you do not need to calibrate the air pressure, press the SET button to
confirm the current setting. For more information on calibrating the air pressure, see "m) Calibration" in part 12
("Functions"). The light intensity unit will start to flash.
• Press the WIND + or PRESSURE - buttons to change the unit. You can choose from Klux, Kfc and W/M
(hectopascals). Confirm your selection with the SET button. The temperature unit will start to flash.
• Press the WIND + or PRESSURE - buttons to change the unit. You can choose from °Celsius or °Fahrenheit.
Confirm your selection with the SET button. The wind speed unit will start to flash.
• Press the WIND + or PRESSURE - buttons to change the unit. You can choose from km/h (kilometres per hour),
mph (miles per hour), knots, m/s (metres per second) and bft (Beaufort). Confirm your selection with the SET
button. The precipitation unit will start to flash.
• Press the WIND + or PRESSURE - buttons to change the unit. You can choose from IN/HR (inches per hour) and
MM/HR (millimetres per hour). Confirm your selection with the SET button. The hemisphere setting will start to flash.
• Press the WIND + or PRESSURE - buttons to change the setting. Select "NHT" if you are located in the northern
hemisphere, or "STH" if you are located in the southern hemisphere. Confirm the setting using the SET button. The
weather station will revert to the home screen.
b) Setting the alarm time and weather alarm
The weather station features an alarm that goes off at a preset time. It also has a visual and acoustic alarm that
is triggered when weather measurements exceed or drop below a preset value. Press any button (except the
LIGHT/SNOOZE button) to silence the alarm.
• To set the alarm, press and hold the ALARM button (3) for 2 seconds. The hour value for the alarm time will start
to flash and "ALM" will be displayed.
• Press the WIND + (5) or PRESSURE - buttons (4) to change the hour value. Confirm your selection with the SET
button (8). The minute value will start to flash.
• Press the WIND + (5) or PRESSURE - buttons (4) to change the minute value. Confirm your selection with the
SET button.
To enable the alarm, press the ALARM button while the hour or minute value is still flashing.
The bell symbol (
The bell symbol (
• The maximum indoor temperature for the weather alarm will start to flash and "HI" will be displayed. Press the
WIND + (5) or PRESSURE - buttons (4) to change the setting. Confirm your selection with the SET button (8).
The minimum indoor temperature for the weather alarm will start to flash and "LO" will be displayed. Press the
WIND + (5) or PRESSURE - buttons (4) to change the setting. The next weather alarm setting will be displayed.
Follow the steps above to configure the other alarm settings in the following order: Indoor humidity, max. value = "HI",
minimum value = "LO" > outdoor temperature, max. value = "HI", minimum value = "LO" > outdoor humidity, max.
value = "HI", minimum value = "LO".
• Confirm the last setting using the SET button. The home screen will be displayed.
• To enable/disable the weather alarm for a particular measurement (e.g. indoor humidity), press the ALARM button
when the desired measurement is displayed. The alarm symbol will be displayed next to the measurement when
the alarm is enabled. It consists of the
) will be displayed. To disable the alarm, press the ALARM button again.
) will disappear from the display.
symbol together with the trigger value.
2
53