Electrical Safety - Eurochron EFWS2900 Notice D'emploi

• The manufacturer shall not be responsible for inaccurate measurements or weather forecasts and any
resulting consequences. This product is designed for private use only. It is not intended for medical
purposes or for providing information to the general public.
d) Electrical safety
• The power adapter is constructed with protection class II.
• Never pour any liquids over electrical devices or put objects filled with liquid right next to the device.
If liquid or an object enters the interior of the device nevertheless, first power down the respective socket
(e.g. switch off circuit breaker) and then pull the mains plug from the mains socket. Discontinue use and
take the product to a specialist repair centre.
• Never use the product immediately after it has been brought from a cold room into a warm one.
The condensation generated could destroy the product. Allow the product to reach room temperature
before connecting it to the power supply and putting it to use. This may take several hours.
• The mains outlet must be located near to the device and be easily accessible.
• Only power the product using batteries or the power adapter provided.
• Only connect the power adapter to a normal mains socket connected to the public supply. Before
plugging in the power adapter, check whether the voltage stated on the power adapter complies with the
voltage of your electricity supplier.
• Never connect or disconnect power adapters if your hands are wet.
• Never unplug the power adapter from the mains socket by pulling on the cable; always use the grips
on the plug.
• When setting up the product, make sure that the cable is not pinched, kinked or damaged by sharp
edges.
• Always lay the cables so that nobody can trip over or become entangled in them. This poses a risk of
injury.
• For safety reasons, disconnect the power adapter from the mains socket during storms.
• Unplug the mains plug from the mains socket if you do not use the device for an extended period of time.
• Do not touch the power adapter if there are any signs of damage, as this may cause a fatal electric
shock! Switch off the mains voltage to the mains socket to which the power adapter is connected (switch
off at the corresponding circuit breaker or remove the safety fuse, then switch off at the corresponding
RCD protective switch, so that all poles of the mains socket are disconnected). Then unplug the power
adapter from the mains socket. Dispose of the faulty power adapter in an environmentally friendly way
and discontinue use. Replace it with a power adapter of the same design.
41