Searching For Outdoor Sensors - Eurochron EFWS 310i Notice D'emploi

The detection of the DCF signal and its evaluation may take several minutes.
Do not move the weather station during this time and do not push any button.
If no DCF reception is possible at the weather station set-up site, set the time and date
manually; see chapter 12. a).

11. Searching for outdoor sensors

If the weather station does not find an outdoor sensor (e.g. in case of bad reception conditions
or after a battery replacement), you can start the search for the outdoor sensor(s) manually.
The weather station can receive and display the measured data of up to 3 outdoor
sensors. Each outdoor sensor must be set to a different transmission channel.
The outdoor sensor enclosed is set permanently to Channel 1; this cannot be
changed.
The sensors available as accessories have a channel selection switch, which you can
set to Channel 2 or Channel 3.
Press and hold the ▼ button (5) until the reception icon for the outdoor sensor signal (17)
flashes on the left of the display.
The sensor search can take several minutes. Do not move the weather station during this time
and do not push any button.
If the outdoor sensor is not found, check its batteries; place the outdoor sensor in
another location, decrease the distance between the weather station and the outdoor
sensor.
Icon flashes: Sensor search
Good reception of outdoor sensor signal
No signal received within the last hour
47