Activate Snooze Function Or Activate Alarm; Switching Between °C/°F Temperature Units; Display Of Minimum/Maximum Values; Trend Displays - Eurochron EFTH 902 Mode D'emploi

j) Activate Snooze Function or Activate Alarm
When the alarm signal sounds at the time set, the associated symbol for the alarm
function flashes (chapter 12. f).
—
Pushing the button "SNOOZE" (8) interrupts the alarm signal for the duration
of 5 minutes. During this time, the symbol for the alarm function and the symbol
"Z " flashes. Then the alarm signal is started again. This procedure can be
Z
repeated several times.
—
Terminate alarm signal by briefly pushing "ALARM" (6).
If you do not manually terminate the alarm signal, it is automatically
terminated after approx. 2 minutes.
k) Switching between °C/°F Temperature Units
Briefly push the button "°C/°F" (7) to switch between the temperature unit °C
(degrees Celsius) and °F (degrees Fahrenheit).
l) Display of Minimum/Maximum Values
—
Press the "MEM" button (9) briefly; the display shows the minimum values for
indoor/outdoor temperature; "MIN" is displayed additionally behind each
temperature value.
—
Press the "MEM" button (9) briefly; the display shows the maximum values for
indoor/outdoor temperature; "MAX" is displayed additionally behind each
temperature value.
—
Press the button "MEM" (9) again briefly to return to display of the current
measured values.
m) Deleting Minimum/Maximum Values
Keep the button "MEM" (9) pressed for 3 seconds. The minimum and maximum
values are then deleted.
n) Trend Displays
To the left of the temperature values or to the right of the humidity values, arrows
indicate the respective trend of the measured value:
Rising
54
Consistent Dropping