Temperature" Function; Switching Between °C/°F Temperature Units; Selecting Outdoor Sensor; Switching Outdoor Sensors Automatically - Eurochron EFWS 91 i Mode D'emploi

13. „TEMPERATURE" FUNCTION
a) Switching between °C/°F Temperature Units
—
Briefly press the „" (11) or „" button (12) repeatedly until the display „
flashes.
—
Keep the „mode" (13) button pressed for about 3 seconds until the temperature
unit (°C/°F) for the indoor/outdoor temperature is switched.
b) Selecting Outdoor Sensor
The weather station can receive and display the measured data of up to 3
outdoor sensors. Each outdoor sensor must be registered on a different
transmission channel.
The included outdoor sensor is firmly set to channel 1; this cannot be changed.
The outdoor sensors available as accessories have a channel selection switch;
set it to channel 2 or 3.
Briefly press the „channel" (15) button to select the desired outdoor sensor for
temperature. The respective channel number is displayed to the left of the outdoor
temperature (3).
c) Switching Outdoor Sensors Automatically
When using more than one outdoor sensor, the weather station can automatically
switch the up to 3 channels. The measured values are displayed for approx. 5 seconds
each.
This function is only available when more than one outdoor sensor is logged
in at the weather station.
—
Keep the „channel" (15) button pressed until the icon „
activate the function (below the channel number).
—
To switch off the function again, keep the „channel" (15) button pressed again
until the icon „
60
" disappears.
"
" is displayed to