Setting Patient Type - Schiller Argus VCM Mode D'emploi

ARGUS VCM

Setting Patient Type

Setting Patient Type
This procedure will allow you to select Patient Type: Adult, Pediatric or Neonatal of This procedure will allow you to select Patient Type: Adult, Pediatric or Neonatal of
monitor. monitor.
ARGUS VCM ARGUS VCM
With the monitor in the normal monitoring mode: With the monitor in the normal monitoring mode:
1. Press the Mode button until the Patient type indicators are on (a selected 1. Press the Mode button until the Patient type indicators are on (a selected
Patient type indicator is shown flashing). Patient type indicator is shown flashing).
2. Select a desired patient type, using the Up/Down (+/-) selection buttons. 2. Select a desired patient type, using the Up/Down (+/-) selection buttons.
3. Press any other button to return to normal operation. If there is no activity for 3. Press any other button to return to normal operation. If there is no activity for
3 seconds, the monitor will return to normal operation. 3 seconds, the monitor will return to normal operation.
Figure 10. Patient Type Setting
Operator's Manual
ARGUS VCM
Using the Monitor
27