Schiller Argus VCM Mode D'emploi page 65

ARGUS VCM
MAP high and low alarm limits
With the monitor in the normal monitoring mode:
1. Press the Alarm button 5 times until MAP high alarm limit is displayed.
2. Leave the limit unchanged or press the Up/Down (+/-) selection buttons as needed
to change the limit to another value.
3. Press the Alarm button once again until MAP low alarm limit is displayed.
4. Leave the limit unchanged or press the Up/Down (+/-) selection buttons as needed
to change the limit to another value.
Figure 34. MAP High Alarm Limit Setting
Figure 35. MAP Low Alarm Limit Setting
Operator's Manual
ARGUS VCM
Alarms and Limits
59