Schiller Argus VCM Mode D'emploi page 43

ARGUS VCM
Initiating MANUAL mode of NIBP operation Initiating MANUAL mode of NIBP operation
1. Press, momentarily, the NIBP start/stop button. 1. Press, momentarily, the NIBP start/stop button.
A single blood pressure measurement will be made. As soon as an NIBP measurement A single blood pressure measurement will be made. As soon as an NIBP measurement
begins, the SYS display dynamically shows the current cuff pressure. begins, the SYS display dynamically shows the current cuff pressure.
Systolic, diastolic, and MAP values are presented when the measurement is completed. The Systolic, diastolic, and MAP values are presented when the measurement is completed. The
measurements remain in the numeric display for 2 minutes or until another NIBP cycle measurements remain in the numeric display for 2 minutes or until another NIBP cycle
begins. begins.
Systolic
Diastolic
MAP
Initiating AUTO mode of NIBP operation
1. Press the Auto button. The latest selected interval is displayed.
2. .Press the Up/Down (+/- ) selection buttons to cycle through the options, which
include (- ), STAT, and a range of intervals: 1, 2, 3, 4, 5, 10, 15, 30, 45, 60, 90, 120, and
240 minutes for taking automatic blood pressures. The dash (-) indicate that automatic
measurement is turned off.
Upon selection, automatic measurement is activated and the initial measurement will be
made immediately after you select an interval.
Figure 18. Manual mode of NIBP operation
Figure 19. Indication of Auto Mode Turn-Off
ARGUS VCM
NIBP Monitoring
Operator's Manual 37