Setting Pulse Tone Volume - Schiller Argus VCM Mode D'emploi

Using the Monitor

Setting Pulse Tone Volume

This procedure will enable you to set Pulse Tone Volume of
With the monitor in the normal monitoring mode:
1. Press the Mode button 4 times until the Pulse Tone Volume setting indicator
2. Select a level of pulse tone volume between 0 and 8, using the Up/Down (+/-)
3. Press any other button to return to normal operation. If there is no activity for
30
ARGUS VCM
and current pulse tone volume are displayed.
selection buttons.
3 seconds, the monitor will return to normal operation.
Figure 13. Pulse Tone Volume Setting
Operator's Manual
ARGUS VCM
monitor.
ARGUS VCM