Power Cable Connections - Schiller Argus VCM Mode D'emploi

ARGUS VCM

Power Cable Connections

Power Cable Connections
WARNING: In the USA, do not connect to an electrical outlet controlled by a wall
switch because the device may be accidentally turned off.
CAUTION: For the safety of patients, use only a Schiller supplied power cord. Using an
unqualified power cord can damage the monitor, and will void the product warranty. If in
doubt about the integrity of the AC power source, the monitor must be operated from its
internal battery.
AC Power
Ensure that the AC outlet is properly grounded and that it is the specified voltage and
frequency (100-240 VAC, 50-60 Hz).
1. Connect the female connector end of the AC power cord to the monitor rear panel
connector.
2. Plug the male connector end of the AC power cord into a properly grounded AC outlet.
3. Verify that the Charging/AC in Indicator is lit. This indicator will be flashing if the battery
needs charging.
Note: If the Charging/AC in Indicator is not lit, check:
Figure 3. AC Power Connection
the power cord
the AC power inlet
ARGUS VCM
Setting up the Monitor
1
AC Power Connector
Operator's Manual 17