Schiller Argus VCM Mode D'emploi page 64

Alarms and Limits
Diastolic high and low alarm limits
With the monitor in the normal monitoring mode:
1. Press the Alarm button 3 times until Diastolic high alarm limit is displayed.
2. Leave the limit unchanged or press the Up/Down (+/-) selection buttons as needed
to change the limit to another value.
3. Press the Alarm button once again until Diastolic low alarm limit is displayed.
4. Leave the limit unchanged or press the Up/Down (+/-) selection buttons as needed
to change the limit to another value.
58
ARGUS VCM
Figure 32. Diastolic High Alarm Limit Setting
Figure 33. Diastolic Low Alarm Limit Setting
Operator's Manual
ARGUS VCM