Schiller Argus VCM Mode D'emploi page 59

ARGUS VCM
Taking a Monitored Measurement Taking a Monitored Measurement
To take a predictive temperature (Celsius Monitored or Fahrenheit Monitored indicator shall To take a predictive temperature (Celsius Monitored or Fahrenheit Monitored indicator shall
be on), the procedures for monitored and predictive temperature measurements are the be on), the procedures for monitored and predictive temperature measurements are the
same, with the following exceptions: same, with the following exceptions:
For monitored measurements: For monitored measurements:
Note: Verify that the temperature measurement type is set to monitored. Note: Verify that the temperature measurement type is set to monitored.
If the measured temperature remains below the minimum measurable temperature for 5 If the measured temperature remains below the minimum measurable temperature for 5
minutes, the temperature cycle is terminated and the temperature display goes blank. To minutes, the temperature cycle is terminated and the temperature display goes blank. To
reactivate the probe, insert it into the probe holder and extract it again. reactivate the probe, insert it into the probe holder and extract it again.
Temperature
- Monitored mode (i.e. Celsius)
Note: The monitor only displays 26°C to 43°C (80°F to 110°F). If the reading is over 43°C
(110°F) or under 26°C (80°F), the monitor will display as follows.
The monitor must be set to take a monitored temperature. The monitor must be set to take a monitored temperature.
The monitor displays the temperature continuously. The monitor displays the temperature continuously.
The measurement continues until the probe is replaced in the probe holder. The measurement continues until the probe is replaced in the probe holder.
Figure 28. Temperature – Monitored Mode
Figure 29. Example display of over 43°C or under 26°C
Temperature Monitoring
Operator's Manual
ARGUS VCM
53