Connecting The Gas Supply; Placing The Wood Set - Dru Verwarming VENTEO SL2 Instructions D'installation Et Mode D'emploi

Connecting the Gas Supply

An approved connecting tap with coupling should be used
in the supply hose (In Belgium this must be B.G.V.
approved). Furthermore:
• Expel all air from the supply pipes/hoses before coupling
to the appliance.
• Do not turn the coupling tap when connecting it to the
gas supply.
• Avoid any pressure on the control tap and pipes.
• Check that all connections are gastight.

Placing the wood set

The appliance is supplied with a wood set.
!Caution: Please, strictly observe the following instructions
for preventing unsafe situations:
• Use only the supplied wood set;
• Place the wood set exactly as described
• Make sure the pilot burner and the space around it are
kept free.
Wood set
The wood set consists of vermiculite (figure 8), chips
(figure 9), resistance wire and 6 logs.
Cover the burners with the vermiculite; spread the
vermiculite evenly, see figure 10.
Caution - You can influence the flame image by moving the
vermiculite, however; the burner floor must remain
38c-1084
2
1
Air inlet baffle
Luchtinlaat geleider
fig. 7
23
INSTRUCTIONS FOR INSTALLATION
3
covered with vermiculite to avoid shortening the
operational life of the burner.
Place log A as indicated in figure 11.
Place log B under log A, in such a way that the recess at
the bottom is placed over the rear of the burner. See
figure 12
Place log C on the ridge on the left corner of the burner,
as indicated in figure 13.
The bevelled corners of log D are placed in the left rear
corner of the combustion chamber, and log D is placed on
block A in an inclined position. See figure 14.
Log E should be placed at the front on the burner's combs
and to the right against the front of log A. Figure 15.
Now place log F (with the scorch mark to the front) on
log A, as indicated in figure 16.
Fill the tray surrounding the burners with chips; spread the
chips evenly. Make sure the chips do not fall into the tray
below. At the front, the chips may only be placed on the
combs in an inclined upward position, as indicated in figure
16.
Spread the resistance wire over the first burner to the left
and right of log B. Make sure the resistance wire does not
get too close to the pilot burner.
Venteo