Securing The Fire; Mounting The Front; Position Of The Appliance, Clearance Round The Appliance; Remote Control - Dru Verwarming Malta Instructions D'installation Et Mode D'emploi

INSTRUCTIONS FOR INSTALLATION
It is important to take into account any other appliances
connected to the same group to avoid exceeding the
maximum consumption for that group.
You can connect the appliance by plugging the mains lead
provided into the mains input (see fig. 1-2-3).

Securing the fire

The fire has 4 adjustable feet. Once these have been
correctly adjusted the fire will be stable enough and does
not need to be secured in place.

Mounting the front

The front is mounted by hanging the hooks into the
appliance at the top and then securing it with screws at
the sides (see fig. 4).These screws serve as earthing and
should be tightened into the side firmly.
Position of the appliance, clearance round the
appliance
The fire is designed to be built into a newly built chimney
breast or a specially designed ornamental fireplace.There
should be at least 10 mm clearance behind the appliance
and at least 5 mm above.The build-in height will depend
on how tall the feet are adjusted.
Now move the appliance into the required position.
Leave a little space round the appliance in the chimney
breast for the wiring and to allow the heat to escape
(see fig. 5).
Screw

Remote control

A standard accessory with the appliance is a remote
control.With this you can switch the heating elements on
and off, regulate the light intensity (the height of the flame
effect) and switch the fire to stand-by.The symbols on the
remote control are explained below.
To regulate the height of the flame effect, press the large
or small flame one or more times.The dimmer has 16
stages.
More flame effect
Heating element
Heating element
Less flame effect
Heating element off
Hot air outlet
38c-1137
fig. 4
Cool air inlet
20
Screw