Safety Measures; Warnings - Dru Verwarming Malta Instructions D'installation Et Mode D'emploi

• If the appliance is damaged in any way, contact the supplier immediately before you install
or use it.
• Do not use the fire outside.
• Do not install the fire in damp surroundings or near a bath, shower or swimming pool.
• The hot-air outlet and cold-air inlet must not be blocked, either completely or partially, in any
way whatsoever.
• The appliance must not be fitted with an insulation blanket or packed in any other way.
• The appliance is suitable for 240V 50Hz and has a maximum nominal load of 2200 Watt.
• The plug must remain accessible at all times after installation.
• The wall socket the fire is to be connected to must be earthed.
• Do not place the fire under the plug socket as the heat could damage it.
• Ensure that curtains and any other combustible materials are at least 50 cm. away from the fire.
• We recommend that the appliance be installed by a qualified installer in accordance with
the current regulations.
• Do not allow children near the fire without supervision and keep the remote control out of
the reach of children.
• Do not use this fire in combination with any other controls such as a timer, thermal regulator
or programmed controller to switch it on automatically (the fire could be covered or
someone could have moved it without you noticing), which could cause a fire.
• In the event of a failure, unplug the fire.
• Never hang wet clothes or towels, etc. on the fire to dry!
• If you leave the fire and remote control on stand-by, a small amount of electricity will
continue to flow to the appliance. We recommend you use the on/off switch to switch the
fire on and off.
• Do NOT use the appliance in an ambient temperature lower than 2ºC or higher than 40ºC.
• Do NOT use the appliance if the humidity is more than 80%.
• Do NOT use the appliance above 2000 m.
• N.B.: This appliance weighs approx. 30 kg, we therefore advise you not to move it unaided.
1. The symbol on the front near the hot-air outlet (fig. a) indicates that this part of
the appliance is extremely hot and that covering the outlet could cause it to
overheat.
2. N.B.! Touching hot parts can cause burns!
3. The fire must not be used if either of the two glass panes is damaged.
4. Always unplug the appliance before carrying out any work on it. You can also switch off the
group it is connected to. Check that there is no current in the appliance before starting any
work on it.

Safety measures

Warnings

18
fig. a