General Notes; Maintenance And Cleaning Instructions; Extra Protection; Thermal Protection - Dru Verwarming Malta Instructions D'installation Et Mode D'emploi

GENERAL NOTES

Maintenance and cleaning instructions

Always make sure the appliance is unplugged
or the group to which it is connected is
switched off in the meter cupboard.
Your appliance should be serviced at least once a year.We
advise you to have this done by a qualified company. Make
sure the fire is completely cool before starting to clean or
inspect it.
The inspection and maintenance must at least warrant that
the appliance is working correctly and safely. Have this
done by your installer or a specialised maintenance
company.
We also recommend you regularly check the appliance for
accumulated dust and clean it, or have it cleaned, if
necessary.
To be able to inspect the air inlet and hot-air outlet for
accumulated dust, you will have to remove the front. See
"mounting the front" above.
In time, dust will collect on the inside of the glass window.
This can be removed with a glass cleaner or a damp cloth.
Do not use corrosive or abrasive substances to clean the
casing. Any damage to the coating, caused by things put on
or against the casing for example, is not covered by the

guarantee.

Extra protection

If the appliance is to be installed in a room where there
are likely to be unsupervised young children or invalids, we
advise you to fit a guard and to keep the remote control
in a safe place.

Thermal protection

The appliance has a thermal cut-out to prevent
overheating, which could occur if the hot-air outlet is
covered. Once it has cooled down the heating element will
switch on again automatically.
Should this safety device be activated for no apparent
reason you should contact your supplier.

Disposal

If you replace or remove the appliance you must dispose
of it in an appropriate manner. Before dismantling the
appliance, it must be disconnected from the electricity by
unplugging the mains lead or switching off the mains for
the group to which the appliance is connected.
Guarantee
The warranty for your DRU appliance will be provided by
your supplier. In case of malfunctions, you should always
contact him.You supplier will contact DRU if he feels this
is necessary.The factory warranty for your appliance is
valid for 2 years after date of purchase.

Troubleshooting

In the highly unlikely event of a fault, we recommend you
contact your supplier.
Possible faults:
The flame effect works and the fan does too
but no heat is emitted from the fire:
The thermal cut-out may have been activated. Once the
device has cooled down, the fire will generate heat again.
If the device is activated again straight away and the
heating element switched off, you should contact your
supplier.
The fire no longer responds to the remote
control:
Perhaps the batteries in the remote control are dead.
Replace them with new ones and if this does not resolve
the problem then contact your supplier.
Please keep this manual carefully.
23
GENERAL NOTES
Decorative electric fire