Installing The Appliance, Clearance Around The Appliance; Switching The Appliance On And Off; Installing And Removing The Front Glass Sheet - Dru Verwarming METRO 80E Mode D'emploi

USER MANUAL
The fuse holders (see Fig. G) can be accessed by removing
the bottom ventilation profi le (see Fig. E) and then the
right ventilation profi le (see Fig. F).
For replacing the fuses, remove the plug from the device
and check whether the two mains supply fuses are defec-
tive. Replace the fuses if they are defective (two 10-Amp.
delay-action fuses), and re-insert the plug, and if the fuses
are again found defective, please contact your supplier.
Under no circumstances should you install fuses of a rating
higher than 10 Amperes. This may have serious consequen-
ces in case of short circuits.
Take due account of the other equipments/ appliances that
are connected to the same group, to ensure that the maxi-
mum power consumption of the group is not exceeded;
please contact your installer for further details.
Fig. E
Fig. F
7. Installing the appliance, clearance around
the appliance
The appliance is designed for built-in installation. However,
due account must be taken of the air currents around the
appliance (your installer will fi nd information about this in
the Installation Manual). As a user, you should ensure that
no objects are placed in front of the appliance, particularly
the hot air outlet and the cold air inlet (see Fig. C).

8. Switching the appliance on and off

The appliance can be switched on or off (see Fig. D) by
operating the switch at the top right of the appliance
(0 or 1).
Attention: the equipment does not consume any further
current if switched off from here.
It is always recommended that this switch should
be used to switch off the appliance for some time
(at night for example).

9. Installing and removing the front glass sheet

Only the installer may remove the effect glass sheet – the
second glass sheet – for service operations!
Attention: the glass may be sharp and cause injury; you are
therefore advised to take appropriate measures for the
same
While installing and removing the glass sheet, ensure that
the appliance and the glass sheet are not damaged!
The component numbers contained in the description of this
appliance are explained in the Annex along with an image of the
specifi ed article.
14
Fig. G