Removing The Glass Sheet; Installing The Glass Sheet - Dru Verwarming METRO 80E Mode D'emploi

9.1 Removing the glass sheet:

1. Removing the air inlet profi le (1) (see Fig. E)
2. Remove the left (2) and the right (3) decorative profi le
by pushing it toward the centre from the bottom
(see Fig. F), and then letting the top move downwards.
The sheet is only blocked at the top against forward move-
ment, and the bottom rests on two support strips
(see Fig. H).
Field A
Top support strips (5)
Bottom support strips (6)
Fig. H
3. Lift the glass sheet (4) off the top support strips
(5 – Fig. F);
4. Pull the bottom forwards slightly and lower the glass
sheet carefully onto the bottom support strips
(6 – Fig. H);
5. The glass sheet may now be held at the top with both
hands;
6. Now remove the glass sheet carefully outwards from
within the fi tting frame (7 – Fig. I) (make sure you do
not damage the frame!);

9.2 Installing the glass sheet:

1. 1. Hold the glass sheet (4) with both hands at the top;
2. Carefully pass the glass sheet into the fi tting frame
(7 – Fig. I) (make sure you do not damage the
frame!);
Field B
3. Rest the bottom of the glass sheet on the bottom support
strips (6 – Fig. H);
4. Tilt the glass sheet slightly inward and rest the top edge
against the left fi eld A and the right fi eld B (fi gure H);
5. Lift the bottom edge of the glass sheet off the bottom
support strips (6 – Fig. H);
6. Carefully raise the glass sheet slightly and let it rest on
the top support strips (5 – Fig. H);
7. Install the left (2) and the right (3) decorative profi le;
8. Install the air inlet profi le (1).
10. Installing the wood/pebbles set
Installing the wood set:
It is preferable to position the wooden trunks as shown in
Fig. J. This is however not a requirement, and a different
position is always possible and will only affect the fl ame
image produced by your appliance.
Installing the pebbles set:
You may place the pebbles anywhere on the base plate.
An example of the same may be found in Fig. K.
Fig. J
15
GEBRUIKSHANDLEIDING USER MANUAL
7
Fig. I
Fig. K
Metro 80E