Publicité
Les langues disponibles
Les langues disponibles
5
Positioning the logs
Distribute the vermiculite evenly over the front and back
burners. Make sure not to get too much vermiculite on
the ignition points of the front and back burners.
The separate logs can be seen in fig. 10, fig. 11 shows the
logs grouped in position.
Log 1: Against the notches on the back burner;
Log 2: Diagonally across log 1 with the knot side down;
Log 3: With the knot side in the corner on log 2;
Log 4: In the middle of the heater against the ridge on log
1, with the front against the teeth on the burner;
Log 5: Slanting backwards and on the front burner
support;
Log 6: In the left-hand corner on log 1 (there is a notch
on the back of log 1);
Log 7: On top of log 5, slanting up towards log 6;
Log 8: Diagonally across log 5 (must not lie on the burner
surface);
Log 9: With the knob in the burner and the front on the
teeth of the front burner;
Sprinkle the chips around the logs.
At the front, the chips can be laid on the burner teeth
(slanting upwards);
Do not cover completely, air must be able to circulate.
Do not use any materials other than those supplied.The
supplied materials are incombustible and have been
manufactured specifically for this appliance.
6
7
4
8
fig. 11
INSTRUCTIONS FOR INSTALLATION
2
1
9
Dismantling / Fitting glass window frame
Remove the decorative panels, supplied separately, 1 and 2
(fig. 8) .
Remove the six self-tapping screws with the spanner
provided (fig. 9).
Holding the handle (4) lift the glass pane.
Now lift the pane out of the hooks by tilting the top
forwards approx 1.5 cm.
Twist the window frame at the bottom of the heater in
the direction of the arrows, as shown in fig. 9.
Reassemble in reverse order.
Remote control
Remote control is supplied as a standard accessory.The
heater has a freely adjustable. Batteries, with a life
expectancy of approximately one year, feed the electrical
supply.The remote control will only work if the pilot light
is lit.
21
3
Passeo
Publicité
Chapitres
