Foreword; Unpacking; Connection; Instructions For Installation - Dru Verwarming PASSEO Instructions D'installation Et Mode D'emploi

INSTRUCTIONS FOR INSTALLATION

Foreword

Dear Customer,
We would like to thank you for buying this DRU product.
Our products have been designed and produced to meet
the highest possible quality, performance and safety
requirements, allowing you to enjoy years of problem-free
use.
The heater has an enclosed combustion chamber. Its
natural draught draws in the combustion air from outside
through a combined inlet-outlet system.The same natural
draught expels the combustion gasses.
In this booklet you will find instructions for the installation
and use of your new appliance. Please read these
instructions and the manual carefully to familiarize yourself
with the appliance. If you require any further support,
please do not hesitate to contact your supplier.

Unpacking

Once the heater has been unpacked, all packaging should
be disposed of in the regular manner.

Connection

This appliance should be connected by a registered
installer.
INSTRUCTIONS FOR INSTALLATION

Type of gas

This appliance is suitable for G20 or G25 natural gas.
Please check that the local gas and pressure correspond
with the specifications on the type identification tag.The
type identification tag is a metal plate.
All regulations regarding gas installation, including any local
regulations, must be observed at all times. The appliance is
to be installed by a registered installer.

Important

• Keep curtains and any other flammable materials at least
50cm away form the appliance.
• Caution! Touching the heater when hot can cause burns
and blisters!
• The appliance should be installed and maintained by a
registered installer.
• Do not install any so-called dust filter on or under the
casing.
• Do not hang wet clothes and towels etc. on the heater to
dry.

Positioning the appliance

The appliance is designed to be built in snugly into a newly
built chimney breast of incombustible and heat-resistant
material.The DRU range includes several suitable chimney
breasts.
For this appliance you will need to use a service flap.
The service flap should be within 1 metre of the fire
because of the length of the pipes.
For the dimensions and installation instructions, see the
section on the service flap.
If you build the chimney breast of any material other than
stone (e.g. Promatect), we advise you to use a fibreglass
wallpaper and not plaster.
If you do use plaster make sure the flanges are not
plastered over as they could crack from the heat of the fire.
Allow sufficient space for the depth of the appliance
(350 mm). Behind the appliance there should be a minimum
space of 0.5 – 1.5 cm.
The built-in height will depend on how high the adjustable
feet are set.
Now move the appliance into the required position.
Allow a little room all round the appliance in the fireplace
so that the heat can escape.
To allow adequate heat removalthe chimney breast should
be well vented.
The free vent area should be at least 200 cm
We advise you to fit vents on both sides.
The DRU range includes suitable design vents.
Take the box of logs and the bag of accessories out of the
combustion chamber by removing the glass pane.
Remove the six self-tapping screws with the spanner
provided (fig. 9).
Holding the handle (4) lift the glass pane.
Now lift the pane out of the hooks by tilting the top
forwards approx 1.5 cm.
Twist the window frame at the bottom of the heater in the
direction of the arrows, as shown in fig. 9.
Reassemble in reverse order.
Connect the appliance.
14
2 .