Connecting The Gas Supply; Placing The Woodset - Dru Verwarming PASSEO SL2 Instructions D'installation Et Mode D'emploi

Connecting the Gas Supply

An approved connecting tap with coupling should be used
in the supply hose (In Belgium this must be B.G.V.
approved). Furthermore:
• Expel all air from the supply pipes/hoses before coupling
to the appliance.
• Do not turn the coupling tap when connecting it to the
gas supply.
• Avoid any pressure on the control tap and pipes.
• Check that all connections are gastight.
Placing the wood set
The appliance is supplied with a wood set.
!Caution: Please, strictly observe the following instructions
for preventing unsafe situations:
• Use only the supplied wood set;
• Place the wood set exactly as described
• Make sure the pilot burner and the space around it are
kept free.
Wood set
The wood set consists of vermiculite (figure 8), chips
(figure 9), resistance wire and 5 logs.
Cover the burners with the vermiculite; spread the
vermiculite evenly.
!Caution - You can influence the flame image by moving
the vermiculite, however;
38c-1084
2
1
Air inlet baffle
Luchtinlaat geleider
fig. 7
25
INSTRUCTIONS FOR INSTALLATION
3
the burner floor must remain covered with vermiculite to
avoid shortening the operational life of the burner.
Place log A as indicated in figure 10. Do pay attention to
the 3 reference points as indicated in figures 11, 12 and 13.
Place log B under log A, in such a way that the recess at
the bottom is placed over the rear of the burner. See
figures 14a and 14b.
Place log C as far to the front as possible, on the burner's
combs.To the right, the log is placed against the side wall,
as indicated in figures 15a and 15b.
Now place log D (with the scorch mark to the front) on
log A, as indicated in figure 16.
Fill the tray surrounding the burners with chips; spread the
chips evenly. Make sure the chips do not fall into the tray
below. At the front, the chips may only be placed on the
combs in an inclined upward position, as indicated in
figure 16.
Spread the resistance wire over the first burner to the left
and right of log B. Make sure the resistance wire does not
get too close to the pilot burner.
Passeo