Hach ORBISPHERE 3100 Manuel D'utilisation Simplifié page 19

6.4 Default measurement configuration settings
1. Instrument settings
Option
Instrument mode Select between continuous or sample mode.
Sample type
2. O2 channel settings
Option
O2 gas unit type Select the gas unit type from the list available
O2 gas unit
O2 high alarm
O2 low alarm
3. O2 advanced settings
Option
O2 measurement offset If required, enter a value (positive or negative) for the measurement
Description
Continuous mode is typically used for process measurement, whereas
sample mode is aimed at lab measurements of small volume individual
samples such as cans, bottles, etc.
Select the sample type from the list available
Description
Select the display unit from the list available
Check the box to set the measurement high alarm.
If set, enter the high level value to trigger the alarm. When measurements
exceed this value an alarm will be triggered
Check the box to set the measurement low alarm.
If set, enter the low level value to trigger the alarm. When measurements fall
below this value an alarm will be triggered
Description
offset. This value will be used to adjust the measurement accordingly
English 19