Installation And Preliminary Operations; Machine Installation (Version With Tank) - Nuova Simonelli MICROBAR II Manuel D'instructions

EN
2. INSTALLATION
AND PRELIMINARY
OPERATIONS
RISK OF POLLUTION
Do not dispose of packaging in the environment
Before carrying out any installation and adjust-
ment operations you must read and fully under-
stand the SAFETY INSTRUCTIONS of this hand-
book. The company cannot be held responsible
for damage to things or injury to persons caused
by failure to comply with the safety instructions
and installation and maintenance instructions
contained in this handbook.
The machine can be used with the following:
Coffee beans
Decaffeinated coffee powder
Milk (not powder) (only CAPPUCCINO version)
The use of any other substance not listed
here above may cause serious damage to the
machine itself.
RISK OF SHORT CIRCUITS
Before connecting the machine to the mains
power supply, please check that the supply volt-
age corresponds to the machine voltage.
NOTE: At the beginning of the daily activities and in
any case, for pauses longer than 8 hours, it
is necessary to change 100% of the water in
the circuits, using the relevant dispensers.
CAUTION
Fig. 4
CAUTION
CAUTION
NOTE: In case of use where service is continuous,
make the above changes at least once a
week.
2.1 MACHINE
INSTALLATION
(VERSION WITH TANK)
Switch off the machine before filling or removing
the water tank.
Once the machine has been withdrawn from the
packaging, carry out the following instructions:
1 Position the unit on a horizontal surface.
2 Open the hatch.
3 Withdraw the water tank by pulling it upwards.
4 Particularly the first time, wash the tank with
soapy water and then carefully, rinsing off any
soap residue.
5 Fill the water tank with water.
6 Make sure that the outside of the water tank is
dry.
7 Return the water tank to its housing.
8 Close the front panel.
CAUTION
Fig. 5
Fig. 6
47