Installation And Preliminary Operations; Machine Installation (Version With Tank); Machine Installation (Version For Direct Connection) - Nuova Simonelli MicroBar Manuel D'instructions

4.

INSTALLATION AND PRELIMINARY OPERATIONS

CAUTION
RISK OF POLLUTION
Do not dispose of packaging in the environ-
ment.
Before carrying out any installation and
adjustment operations you must read and
fully understand the SAFETY INSTRUC-
TIONS of this handbook.
The company cannot be held responsible
for damage to things or injury to persons
caused by failure to comply with the safety
instructions and installation and mainte-
nance instructions contained in this hand-
book.
CAUTION
RISK OF SHORT CIRCUITS
Before connecting the machine to the mains
power supply, please check that the supply
voltage corresponds to the machine voltage.
4.1
MACHINE
INSTALLATION
(VERSION WITH TANK)
WARNING
Switch off the machine before filling or
removing the water tank.
Once the machine has been withdrawn from
the packaging, carry out the following instruc-
tions:
1 Position the unit on a horizontal surface.
Fig. 14
2 Open the hatch.
3 Withdraw the water tank by pulling it
upwards.
4 Particularly the first time, wash the tank
with soapy water and then carefully rinse
off all soap.
5 Fill the water tank with water.
6 Make sure that the outside of the water
tank is dry.
7 Return the water tank to its site.
8 Close the hatch.
WARNING
The water hardness must be less then
4° - 6° fr (french degree).
The chlorine contents is max 100 mg per
litre (0.00000361 lb/cu in).
Otherwise the conditions of guarantee of
the machine will expire.
4.2
MACHINE
INSTALLATION
(VERSION FOR
DIRECT CONNECTION)
Fig. 15 Once the machine has been withdrawn from
the packaging, carry out the following instruc-
tions:
1 Position the unit on a horizontal surface.
2 Remove the pipe with 3/4" coupling from
the hatch in the top of the machine.
Fig. 16
Fig. 17
43