Machine Block Alarm Messages - Nuova Simonelli MICROBAR II Manuel D'instructions

EN
10.

MACHINE BLOCK ALARM MESSAGES

DISPLAY INDICATION
UPPER PISTON MOTOR
GROUP ALARM
Xxxxxx
Group Error
HEATER FILLING ALARM
Boiler Filling
TURBINE ALARM
Once having detected the alarm,
on the display, the control unit
alternates the message relative
to the current beverage with the
error message concerning such
function. For instance:
Flowmeter Error
WATER TANK EMPTY ALARM
Refill WaterTank
CAUSE EFFECT
During the group The control unit
will halt whatev-
handling phase,
the upper piston er cycle is on by
exceeded maxi- turning off both
mum set time the movement
by 10 seconds actuator
before recogniz- those for drink
ing motor pickup. delivery;
operator will not
be able to make
selections on
the keyboard.
The heater fill- The
ing stage has will stop.
exceeded the 3
minute maximum
time; the probe
level is uncov-
ered.
The volume The delivery will
counter will continue for up
not send any to 60 seconds
impulses to the or for as long
control unit for 5 as any of the
seconds. coffee
drink keys are
pressed.
The water tank is The coffee will
empty. not be delivered
and the dosing
will be halted
while in pro-
gress.
SOLUTION
Open and close the machine
door.
If the alarm reappears after the
second time of taying, call the
and Service Technician.
the
machine Contact the Service Technician.
Open and close the machine
door. The control unit will repeat
the machine starting up proce-
dure.
based In case the alarm persists, the
machine can be used as a manu-
al appliance.
Press the selected key to start
the dosing;
Once the desired dose has
been delivered in the cup, press
the same key to halt the dose
being delivered.
Call the Service Technician.
Fill the water tank.
Use the Hot Water key to elimi-
nate any air bubbles.
73