Energy Saving; Technician Mode Programming Cycle - Nuova Simonelli MICROBAR II Manuel D'instructions

EN
7. ON/OFF PROGRAM.
By pressing the ENTER key, it is possible to
access the setting of the automatic switch-
ing ON/OFF of the machine, only with the
machine switch in the ON position.
The display will read as follows:
Sunday
Day Off
NOTE: The default setting for the machine
has all days of the week set to
"STANDBY" and therefore, to switch
the machine on/off, the main switch
must be used.
KEY FUNCTIONS
: When not used for setting, allow to scroll
the days of the week and show their set-
ting. After SATURDAY, press the
to return to the previous menu. When
used in the setting, the value to set is
increased/decreased.
ENTER: Access to single day setting. When
pressed in setting, it confirms the value
set and scrolls to the next one.
RESET: Return to the daily setting visualization.
When pressed once more, it resets the
setting of the visualized day.
The display will read as follows:
Sunday
ON07 : 30
key
OFF23 : 30
8.

ENERGY SAVING

By pressing the ENTER key, it is possible to set the
time after which the machine enables the energy-
saving device, whilst keeping the water tank at work-
ing temperature. The display will read:
Energy Saving
00 : 00
KEY FUNCTIONS
: Increase / decrease of the activation time
of the ENERGY SAVING, with intervals of
30 minutes.
The function is deactivated when the timer
is left at zero.
ENTER: /
RESET: Return to the previous menu with the con-
firmation of the value set.
5.5 TECHNICIAN
MODE PROGRAMMING
CYCLE
To access the functions that can only be programmed
using the TECHNICIAN MODE, scroll through all of
the functions that can be accessed from the USER
MODE until the display reads as follows:
Password
* * * * *
Enter the correct password to view the first item in
the programming menu that can be accessed from
the TECHNICIAN MODE.
NOTE: The default standard password is 5 times
2
key number
NOTE: If an incorrect password is entered, the
machine will automatically quit the program-
ming mode to enter the machine ready
mode.
:
57